W1264—3" Rosette Knife

This model has been discontinued


These high speed steel knives will produce intricately-carved rosettes - or even raised panels - on a drill press. You can also plane smaller stock by using the flat profile knife. Knives are ground on opposite sides, so only one knife is needed. For best results, we advise using birch, cherry or oak, at machine speeds of 250 - 350 RPM. This one-piece Rosette Knife installs in the W1250 Cutterhead to make the profile shown. Total knife width is 3", and 1/8" thick. Woodstock model W1250 Cutterhead required for use


  • 2-15/16" rosette
  • HSS
California Proposition 65 Warning